X2 - V1.4

#

Vector Controls X2 Operating System Version 1.4

X2-Operating System

The X2-Operating system consists of a standardized method to operate and configure a range of controllers and sensors. The system is built on pre-programmed control and function blocks which can be configured using a parameterization routine. All X2-type products use the same philosophy and can be configured using the same tools and methods. All X2-type products can be configured using the standard operation terminals, the PC based tool EasySet™ from Vector Controls or remotely through bus communication where available.

> Read more about the EasySet tool

X2-Introduction

X2-Documentation

Detailed setup, configuration and operation instructions can be fond in the tabs below.

 

X2 Engineering

Engineering Guidelines

X2 Operation

Operation Manuals

X2 BACnet

BACnet Communication Guidelines

X2 Modbus

Modbus Communication Guidelines

X2 Version History

Version 1.4 R9 (June 30, 2020)

  • Re-activate step delay for loop switching states

Version 1.4 R8 (June 9, 2020)

  • Add factor to temperature compensation for TRI2

Version 1.4 R7 (May 7, 2020)

  • Bug fix RH display in Fahrenheit mode for TRI2

Version 1.4 R6 (December 23, 2019)

  • Improve communication with RH sensor if init problem
  • Improve temperature compensation settings for TRI2

Version 1.4 R5 (May 29, 2019)

  • Change to run time schedule even no RTC is installed
  • Increase of sampling of analog input ; Bug fix LED of TCI2
  • Improvement of TRI2 sensing ; Adjust for Sensirion VOC sensor for TRI2/SOC2
  • Bug fix °F/°C change

Version 1.4 R4 (May 29, 2018)

  • Bug fix cascade flag for loop h/c change on enable routine
  • PWM high limit frequency mode
  • Change in clock detection for Err3 and for clock initialization

Version 1.4 R3 (May 15, 2018)

  • Bug fix CO2 calculation of delta for sensor inputs

Version 1.4 R2 (March 22, 2018)

  • Change of init string to detect TRIAC and passive inputs
  • Bug fix compensation parameter
  • Bug fix TCI2-C input measurement

Version 1.4 R1 (März 19, 2018)

  • Change configuration word to enable Brown out interrupt

Version 1.4 R0 (November 14, 2017)

  • Added Special input function
  • Changed timing philosophy for fan/do to parallel
  • In PWM if demand is 0, do not start new cycle
  • Add signal selection for AO
  • Add added features for CO2 sensors (calib, ABC on/off)
  • Add driver for VOC sensor made by Sensirion